AccuQuilt - GO! Crazy Petals Die

Flower power! You'll love quilting up a field of fresh flowers with the GO! Crazy Flowers die. Fun and versatile, this die includes petals and centers you can mix and match to create a variety of flowers or use with other GO! floral dies to custom design your own quilted garden.

AQ Cutting Mat Required: GO! Cutting Mat, 6 in. x 6 in. (15.2 cm x 15.2 cm)

How to Die Cut Crazy Petals Shapes:

Apply fusible web product to the wrong side of the fabric, following manufacturer’s instructions, before cutting for fusible appliqué.  

• Large Petal: Cut and fuse 2" x 2 7/8" rectangles. Cut 13 large petals across the width of fabric. One yard of 40" wide fabric cuts 234 large petals.
• Medium Petal, Small Petal and Centers: Place scraps on blade and cut. 

Why Quilters Love the GO! Crazy Petals Die: 

• Brighten up any project with flowers created with the GO! Crazy Petals die, from quilt tops to table runners. 
• No templates required. The GO! Crazy Petals die includes six shapes that are typically difficult to cut by hand. 
• Mix and match the petals and centers to create a variety of flowers or use with other GO! floral dies to custom design your own quilted garden.
• Quickly and easily cut four of each pre-fused applique shape in one pass thru the cutter (fusible counts as one half layer of fabric). 
• Cut flower shapes out of a variety of fabrics: cotton, batiks, wool, felt, flannel, fleece, Cuddle® fabrics and more! 
• A great way to use up scraps. 
• Free pattern downloads available to get you started. 
• Charm Pack-friendly.

AccuQuilt Benefits: 

• Cut so much more fabric in less time. 
• Get accurate cuts every time -- No slipping rulers or mistakes
• Easiest to use -- Simply place die on cutter, then fabric and cutting mat on top
• Save fabric with Two Tone Foam -- Get more out of your fabric by placing it only over the shape you want to cut. 
• Safe to use -- No blades come anywhere near your fingers

Die Tips: 

• With some fabrics, after cutting, a thread or two will remain where die blades meet. Snip threads with scissors. 
• Blades on some dies are positioned at an angle.  Align fabric to edge of shape, not edge of die board. 
• Use good quality fabric to reduce fabric stretch. 
• It's always a good idea to test cut one shape before cutting many shapes to ensure fabric orientation is correct.